[Initial Startup]; [Startup Input Select]; [Date And Time] - Panasonic PT-MZ20K Operating Instructions Manual

[NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specific period. The time before switching to standby can be set.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10MIN.] - [90MIN.]
Note
f The [NO SIGNAL SHUT-OFF] setting item is common with the following menu item.
g The [PROJECTOR SETUP] menu → [POWER MANAGEMENT] → [NO SIGNAL SHUT-OFF]

[INITIAL STARTUP]

Set the startup method when the <MAIN POWER> switch is set to <ON>.
1) Press as to select [INITIAL STARTUP].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]

[STARTUP INPUT SELECT]

Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3) Press asqw to select the input, and press the <ENTER> button.
[LAST USED]
[HDMI1]
[HDMI2]
[SDI]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.

[DATE AND TIME]

Set the time zone, date, and time of the built-in clock of the projector.
Setting the time zone
1) Press as to select [DATE AND TIME].
2) Press the <ENTER> button.
f The [DATE AND TIME] screen is displayed.
138 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the no signal shut-off function.
Sets the time in increments of 10 minutes.
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
Starts up the projector in standby.
Starts projecting immediately.
Keeps the input selected last.
Sets the input to HDMI1.
Sets the input to HDMI2.
Sets the input to SDI.
Sets the input to DIGITAL LINK.
Sets the input to DIGITAL LINK, and switches the input of the DIGITAL LINK output supported device
*1
to the specified input.