Using The Remote Control; Inserting And Removing The Batteries; Setting Remote Control Id Numbers; Connecting To The Projector With A Cable - Panasonic PT-DZ770E Operating Instructions Manual

Using the remote control

Using the remote control
Inserting and removing the
batteries
1) Open the cover.
2) Insert the batteries and close the cover
(insert the
▶
z When removing the batteries, perform the steps
in reverse order.
Setting Remote control ID
numbers
When you use the system with multiple projectors,
you can operate all the projectors simultaneously or
each projector individually using single remote control,
if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same
ID number on the remote control.
The factory default ID number of the projector is
set to [ALL]. When using a single projector, press
the <ID ALL> button on the remote control. Also,
you can control a projector if you press the <ID
ALL> button on the remote control even if you do
not know the projector ID.
■ How to set ▶
1) Press the <ID SET> button on the
remote control.
2) Within five seconds, press the two-
digit ID number set on the projector
using the number (<0> - <9>) buttons.
▶
z If you press the <ID ALL> button, you can
operate the projectors regardless of the setting
of the projector's ID number.
Attention
z Since the ID number of the remote control can be
also set without the projector, do not press the <ID
SET> button carelessly. If the <ID SET> button
is pressed and no number (<0> - <9>) buttons
are pressed within the next five seconds, the ID
number returns to its original value before the <ID
SET> button was pressed.
22 - ENGLISH
(ii)
(i)
side first).
z The ID number set on the remote control will
be stored unless it is set again. However, it will
be erased if the remote control is left with dead
batteries. Set the same ID number again when the
batteries are replaced.
Note
z Set the ID number of the projector from the
[PROJECTOR SETUP] menu → "[PROJECTOR
ID]" ( page 66).

Connecting to the projector
with a cable
When you use the system with multiple projectors,
configure the units as in the following figure. Use a
commercial M3 stereo mini jack cable and connect
the other devices to the <REMOTE 1 IN>/<REMOTE
1 OUT> terminals of the projector.
The remote control is effective even in places where
an obstacle stands in the light path or where devices
are susceptible to outside light.
M3 stereo mini jack cable
(commercially available)
Connect to remote
control wired terminal
Attention
z Use a cable that is 15 m (49'2") or shorter, with 2
core shield. The remote control may not operate
when the length of the cable exceeds 15 m (49'2")
or when the shielding of the cable is inadequate.
Connecting terminals
Connect to the second
projector
Remote
control