[Advanced Menu]; [Digital Cinema Reality]; [Blanking]; [Auto] *1 - Panasonic PT-DZ770E Operating Instructions Manual

[ADVANCED MENU]

[ADVANCED MENU]

Select [ADVANCED MENU] from the main
menu, and select the item from the sub-menu.
Refer to "Navigating through the menu"
( page 44) for the operation of the menu

screen.
z After selecting the item, press ▲▼◀▶ to set.

[DIGITAL CINEMA REALITY]

You can increase the vertical resolution and enhance
the picture quality by performing the cinema
processing when the PAL (or the SECAM) 576i signal,
the NTSC 480i, 1080/50i, and 1080/60i signals are
input.
1) Press ▲▼ to select [DIGITAL CINEMA
REALITY].
2) Press ◀▶ to switch [DIGITAL CINEMA
REALITY].
▶
z The setting will change as follows each time
you press the button.
[AUTO]
(when a 576i or 1080/50i signal is input)
(when a 480i or 1080/60i signal is input)
Performs automatic detection and
[AUTO] cinema processing.
(Factory default)
[OFF] Unforced cinema processing.
Forced cinema processing
[25p FIXED] (2:2 pulldown) is performed when a
576i or 1080/50i signal is input.
Forced cinema processing
[30p FIXED] (2:2 pulldown) is performed when a
480i or 1080/60i signal is input.
Note
z When a signal other than a 2:2 pulled-down signal
is set to [25p FIXED] or [30p FIXED] in [DIGITAL
CINEMA REALITY], picture quality deteriorates.
(Vertical resolution will degrade.)
54 - ENGLISH
[OFF]
[25p FIXED]
[30p FIXED]

[BLANKING]

The blanking width is adjusted when there are noise
at the edge of the screen or the image is slightly
running out from the screen when an image from the
VCR or other devices are projected.
1) Press ▲▼ to select [BLANKING].
2) Press the <ENTER> button.
▶
z The [BLANKING] adjustment screen is
displayed.
3) Press ▲▼ to select the adjustment
item.
4) Press ◀▶ to adjust the blanking.
▶
z Adjustment values will change between 0 and
959 for left and right, and between 0 and 599
for top and bottom.
When correcting blanking at the top of the screen
[UPPER]
Press ◀ to move the
blanking zone upward.
Press ▶ to move the
blanking zone downward.
When correcting blanking at the bottom of the
screen [LOWER]
Press ▶ to move the
blanking zone upward.
Press ◀ to move the
blanking zone downward.
When correcting blanking at the left of the screen
[LEFT]
Press ▶ to move the
blanking zone to the right.
Press ◀ to move the
blanking zone to the left.
When correcting blanking at the right of the
screen [RIGHT]
Press ◀ to move the
blanking zone to the right.
Press ▶ to move the
blanking zone to the left.