[Network] Menu; [Network Setup]; [Network Control]; [Network Status] - Panasonic PT-DZ770E Operating Instructions Manual

[NETWORK] menu

[NETWORK] menu
Select [NETWORK] from the main menu, and
select the item from the sub-menu.
Refer to "Navigating through the menu"
( page 44) for the operation of the menu

screen.
z After selecting the item, press ▲▼◀▶ to set.

[NETWORK SETUP]

Perform the initial setting of the network before using
the network function.
1) Press ▲▼ to select [NETWORK
SETUP].
2) Press the <ENTER> button.
▶
z The [NETWORK SETUP] screen is displayed.
3) Press ▲▼ to select an item, and
change the settings according to the
operation instructions of the menu.
[PROJECTOR Change the setting when using a
NAME] DHCP server.
Set the item to [ON] when using
a DHCP server to automatically
[DHCP]
acquire the IP address. Set to [OFF]
when not using a DHCP server.
Enter the IP address when not
[IP ADDRESS]
using a DHCP server.
[SUBNET Enter the subnet mask when not
MASK] using a DHCP server.
[DEFAULT Enter the default gateway address
GATEWAY] when not using a DHCP server.
[STORE] Save the current network settings.
4) Press ▲▼ to select [STORE], and
press the <ENTER> button.
5) When the confirmation is displayed,
select [OK] or [CANCEL], and press
the <ENTER> button.
82 - ENGLISH
Note
z When using a DHCP server, confirm that the DHCP
server is running.
z Consult your network administrator regarding the IP
address, subnet mask, and default gateway.

[NETWORK CONTROL]

Set up the control method of the network.
1) Press ▲▼ to select [NETWORK
CONTROL].
2) Press the <ENTER> button.
▶
z The [NETWORK CONTROL] screen is
displayed.
3) Press ▲▼ to select an item, and press
◀▶ to change the setting.
[WEB Set to [ON] to control with the Web
CONTROL] browser.
[PJLink Set to [ON] to control with the
CONTROL] PJLink protocol.
Set to [ON] to control with the
<SERIAL IN>/<SERIAL OUT>
[COMMAND terminal control command format
CONTROL] ( page 115).

Refer to "Control commands via
LAN" (

[COMMAND Set the port number used for
PORT] command control.
[CRESTRON Set to [ON] to control with
RoomView] RoomView of Crestron.
Set to [ON] to control with the
[AMX D.D.]
controller of AMX.
Save the current network control
[STORE]
settings.
4) Press ▲▼ to select [STORE], and
press the <ENTER> button.
5) When the confirmation is displayed,
select [OK] or [CANCEL], and press
the <ENTER> button.

[NETWORK STATUS]

Displays the status of the projector network.
1) Press ▲▼ to select [NETWORK
STATUS].
2) Press the <ENTER> button.
▶
z The [NETWORK STATUS] screen is displayed.
page 111).