Table of Contents
Advertisement
[COMMAND]
[INPUT]
[OPERATING MODE]
[IN STANDBY
MODE(AUDIO)]
[VOLUME]
*1 The [COMPUTER2] command is disabled when the [DISPLAY OPTION] menu → [COMPUTER IN/OUT] → [COMPUTER2 SELECT] is set to
[COMPUTER1 OUT].
*2 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
f After the command is fixed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. ( x page 109)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.
[INITIAL STARTUP]
Set the startup method when the <MAIN POWER> switch is set to <ON>.
1)
Press as to select [INITIAL STARTUP].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]
[STARTUP INPUT SELECT]
Set the input when the projector is switched on to start projection.
1)
Press as to select [STARTUP INPUT SELECT].
2)
Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3)
Press asqw to select the input, and press the <ENTER> button.
[LAST USED]
[COMPUTER1]
104 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Detailed settings of
[COMMAND]
[COMPUTER1]
[COMPUTER2]
*1
[VIDEO]
[HDMI1]
[HDMI2]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
[NORMAL]
[ECO]
[QUIET]
[USER]
[OFF]
[ON]
[0] - [63]
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
Starts up the projector in standby.
Starts projecting immediately.
Keeps the input selected last.
Sets the input to COMPUTER1.
Switches the input to COMPUTER1.
Switches the input to COMPUTER2.
Switches the input to VIDEO.
Switches the input to HDMI1.
Switches the input to HDMI2.
Switches the input to DIGITAL LINK.
Switches the input to DIGITAL LINK, and switches the input of the
*2
Panasonic twisted-pair-cable transmitter to the specified input.
Prioritizes luminance.
Controls the power to increase the life of the light source although
the luminance is lower than that of [NORMAL].
Prioritizes the operation with less noise although the luminance is
lower than that of [NORMAL].
Controls the power with the setting set in [USER].
Stops the audio output during standby.
Outputs the audio during standby.
Sets the volume.
Description
Advertisement
Table of Contents
