Verifying The Stack; Figure 60: Show Stack Command - Allied Telesis AT-IX5-28GPX Installation Manual

Chapter 8: Powering On the Stack

Verifying the Stack

awplus> show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
3 -
4 -
Operational Status
Stack MAC address
awplus(config)#
106
To verify stack operations, perform the following procedure:
1. Establish a local management session on any switch in the stack. For
instructions, refer to "Starting a Local Management Session" on
page 72.
2. From the User Exec mode, enter the SHOW STACK command:
awplus> show stack
The command lists the switches in the stack. An example is shown in
Figure 60.
MAC address
0015:774f:ed30
0015:774f:65ab
0015:774f:d4a7
0015:774f:c431
0015:774f:ed30
Figure 60. SHOW STACK Command
Here are some things to consider:
The command should list all the switches in the stack. If the list is
incomplete, refer to Chapter 10, "Troubleshooting" on page 117.
The Operational Status field displays "Normal operations" when
the switches are connected in the ring topology and "Ring topology
is broken" when the switches are connected in the linear topology.
The priority values will be 128, the default value, if they have not
been changed on the switches.
Given that there is no relationship between the ID numbers and the
selection of the master switch, the active master in the SHOW
STACK command might not have the ID number 1.
3. Do one of the following:
If you want to change the priority values of the switches, go to
"Setting the Priority Numbers" on page 107. The procedure is
optional.
Otherwise, go to Chapter 9, "Cabling the Networking Ports" on
page 109, to continue with the installation.
Priority Status
128 Ready
128 Ready
128 Ready
128 Ready
Normal operations
Role
Active Master
Member
Member
Member