Chapter 8: Powering On The Stack - Allied Telesis AT-IX5-28GPX Installation Manual

Gigabit ethernet switch
Hide thumbs Also See for AT-IX5-28GPX:
Table of Contents

Advertisement

Chapter 8
Powering On the Stack
This chapter contains the following procedures:
"Powering On the Switches Individually" on page 102
"Powering On the Switches Simultaneously" on page 104
"Verifying the Stack" on page 106
Perform "Powering On the Switches Individually" on page 102 if you want
to control the assignment of the ID numbers to the switches of the stack.
The numbers are assigned in the order in which you power on the units.
Otherwise, perform "Powering On the Switches Simultaneously" on
page 104 to have the switches assign the numbers automatically.
After the ID numbers are assigned, you may change them with the STACK
RENUMBER command, described in the Software Reference: AlliedWare
Plus Operating System for IX5-28GPX Switches.
Caution
You should not change the ID numbers of the switches after you
begin to configure the parameter settings. Otherwise, the stack
might assign configuration settings to the wrong units.
101

Advertisement

Table of Contents
loading

Table of Contents