Table of Contents
Advertisement
Cabling Switches with AT-StackOP/0.3 or AT-StackOP/9.0
Transceivers
For guidelines to cabling the switches with AT-StackOP/0.3 or AT-
StackOP/9.0 fiber optic transceivers, refer to "Planning a Stack" on
page 57. To cable switches with fiber optic transceivers, perform the
following procedure:
1. Remove a dust cover from either the S1 or S2 slot on the switch.
2. To install the transceiver in the S1 slot, position it with the handle on
top, as shown in Figure 55. To install it in the S2 slot, position it with
the handle on the bottom.
Handle
Figure 55. Handle on the AT-StackOP/0.3 and AT-StackOP/9.0
Transceivers
IX5-28GPX Installation Guide
97
Advertisement
Table of Contents
