Distribute The Alert Message - Bosch Plena Voice Alarm System Installation And Operation Manual

Plena Voice Alarm System
7.4.7

Distribute the alert message

Proceed as follows to distribute the default alert message:
–
–
Select zones
Select the zones to which the default alert message must be distributed with the Zone select
buttons on the front of the voice alarm controller or the remote controls (see Figure 7.15). A
red LED indicates the zones to which the default alert message is distributed.
–
–
NOTICE!
If no additional action is taken within 10 seconds after the last Zone select button has been
pushed (for example pushing the Alert message button), the zone selection is cancelled.
Figure 7.15 Zone select buttons
To select all zones, push the All call button on the front panel of the voice alarm controller or
the remote controls (see Figure 7.16).
Figure 7.16 All call button
Start the alert message
Push the Alert message button on the front of the voice alarm controller or the remote
controls to distribute the default alert message (see Figure 7.17). The message is only
distributed to the selected zones.
–
–
Figure 7.17 Alert message button
Bosch Security Systems B.V.
Select the zones.
Start the alert message.
If the indicator of a Zone select button is off, the zone is not selected. Push the button to
select the zone.
If the indicator of a Zone select button is on, the zone is selected. Push the button to
deselect the zone.
Fault
EMG
Ack
Zone select
Reset
Zone1
Alert message
Alarm message Indicator test
EMG mic
If the red Alert message indicator is off, the alert message is not distributed. Push the
Alert message button to distribute the default alert message.
If the red Alert message indicator is on, the message is distributed. Push the Alert
message button to stop distributing the default alert message.
Alert message All call
Alarm message Indicator test
EMG mic
Installation and Operation manual
Zone2
All call
Operation | en
9922 141 1037x (V2.16) | V0.6 | 2011.09
81