Bosch Plena Voice Alarm System Installation And Operation Manual page 30

Hide thumbs Also See for Plena Voice Alarm System:
Table of Contents

Advertisement

30
en | System overview
6.
7.
8.
9.
10. Ground:
11. Firmware upgrade connector:
12. Firmware upgrade switch:
13. Remote control extension sockets:
14. Configuration settings:
15. Controller socket:
16. Emergency microphone volume control:
17. Monitoring speaker volume control:
18. Trigger outputs:
19. Status outputs:
20. 24 V DC input:
9922 141 1037x (V2.16) | V0.6 | 2011.09
Fault acknowledge:
A push button to acknowledge the fault state (see section 7.5 ).
Fault reset:
A push button to reset the fault state (see section 7.5 ).
Fault indicators:
Twelve yellow system fault LEDs (Processor reset, Network, Call/EMG, Music/Spare,
Ground short, Input, Mains, Battery, Message, EMG mic, RCP and Router) and twelve
yellow loudspeaker line fault LEDs. Fault indication is only possible if supervision is
enabled (see section 7.5.3 ). If supervision is disabled, the yellow Disabled LED is lit.
Indicator test button:
A button to test all LEDs on the front panel of the fireman's panel and all connected
remote control extensions. All LEDs are lit as long as the button is pushed (see section
7.5 ).
A connection to electrically ground the fireman's panel.
An RS232 connector to connect a PC to upgrade the firmware of the fireman's panel.
A switch to upgrade the firmware of the fireman's panel.
Two redundant RJ45 sockets to connect remote control extensions to the fireman's
panel (see section 5.4.2 ).
A set of DIP switches to configure the fireman's panel (see section 6.5 ).
One RJ45 socket to connect the fireman's panel to the voice alarm controller (see
section 5.4.1 ).
A rotary knob to set the volume of the hand-held emergency microphone.
A rotary knob to set the volume of the monitoring loudspeaker.
Three general purpose trigger outputs. For future use.
Three status outputs to send the status of the Plena Voice Alarm System to third party
equipment (see section 5.8.3 ).
One 24 V(DC) input to connect the fireman's panel to a power supply (see section
5.8.4 ).
Installation and Operation manual
Plena Voice Alarm System
Bosch Security Systems B.V.

Advertisement

Table of Contents
loading

Table of Contents