Plena Voice Alarm System
1
Safety
1.1
Important Safeguards
Prior to installing or operating this product, always read the Important Safety Instructions
which are available as a separate document (9922 141 7014x). These instructions are
supplied together with all equipment that can be connected to the mains.
1.2
Important Notices
When using routers, keypads or more than one call station, configure the controller using the
supplied software.
Use shielded cable (Cat-5) between the routers and the controller. Do not connect the shield
to both the controller and the router!
The factory default setting of the Plena Voice Alarm Controller is as follows:
–
–
–
–
Bosch Security Systems B.V.
Stand-alone unit configured for an ISO 60849 compliant system when used with a spare
power amplifier from the Plena range and compliant wiring and loudspeakers.
One channel system.
Supervision on for:
–
Loudspeaker lines
–
(90 seconds interval, 15% accuracy)
–
Main and spare power amplifier
–
Short to ground ("Ground short")
–
Mains and battery power
–
EMG mic
–
Memory
For the remote controls to function, all firmware must be version 2.0 or higher. The
factory-installed firmware is indicated on every component of the voice alarm system
(Controller, Router, Call Station, Fireman's Panel, Remote Control, Remote Control
Extension, Remote Control kit, Remote Control Extension kit). If a label is not present,
the firmware version is 1.x.
Installation and Operation manual
Safety | en
9922 141 1037x (V2.16) | V0.6 | 2011.09
9