Bosch Plena Voice Alarm System Installation And Operation Manual page 133

Plena Voice Alarm System
9 Disablement condition (option with requirements)
Clause / Requirement
9.1 General requirements
9.1.1 Disablements in accordance with the
requirements of 9.4 shall inhibit all
corresponding mandatory indications and/or
outputs but shall not prevent other mandatory
indications and/or outputs.
9.1.2 The VACIE shall have provision to
independently disable and re-enable the
function specified in 9.4 by means of manual
operations at access level 2.
9.1.3 The VACIE shall be in the disabled
condition while a disablement in accordance
with the requirements of 9.4 exists.
9.1.4 Disablement and re-enablement shall not
be affected by a reset from the voice alarm
condition or from the fault warning condition.
9.2 Indication of the disabled condition
The disabled condition shall be indicated
visibly, by means of
a
b
9.3 Indication of specific disablements
9.3.1 Disablements shall either be indicated
within 2 s of the completion of the manual
operation or, where a disablement cannot be
completed within 2 s, it shall be indicated
within 2 s that the disabling process is running.
9.3.2 The same light-emitting indicator may be
used as that for the indication of the
corresponding fault, although the indication
shall be distinguishable.
9.3.3 If the indication is on an alphanumeric
display, which cannot simultaneously indicate
all of the disablements because of its limited
capacity, at least the following shall apply:
a
Bosch Security Systems B.V.
a separate light emitting indicator (the
general disablement indicator), and
an indication for each disablement, as
specified in 9.3 and 9.4.
the presence of disablement indications
which have been suppressed shall be
indicated;
Installation and Operation manual
Compliance
Praesideo does not support the
disablement condition.
9922 141 1037x (V2.16) | V0.6 | 2011.09
| en 133
Signature