Output Setting - Strong SRT 5392 User Manual

1. If Time Mode is not highlighted, press CH ▼or CH ▲ on the remote control until it is.
2. Press VOL or VOL
3. If you select Time Zone, click CH ▼ to highlight the Time Zone option. Press VOL
select the state in which you live in. Now go to step 5 below.
4. If you select Local System, click CH ▼ to highlight the Current Time option. Now press VOL
VOL to move from digit to digit. The active digit will appear with an underline. Using the
number keys on the remote control, enter the correct number for this digit. Continue until you
have set all the digits for the date and time.
NOTE: The date and time formats are DD/MM/YYYY and HH/MM (24-hour format) respectively.
5. Press the red button on the remote control to save the time settings and move onto the Output
Setting screen.
6. A message appears asking if you want to save your settings. Press OK to save your settings.

Output setting

The Output Settings options allow you to set your video and display preferences. You can set:
• Video output (YUV/Component video, RGB,
CVBS/Composite video). The selection you
make here should match the method you
have used for connecting the SRT 5392 to
your TV.
• TV screen mode (4:3 Letterbox, 16:9 or 4:3)
• SPDIF Output ((Enable, Disable). Enable this
option if you are routing audio through a
Dolby Digital decoder amplifier.
to select Local System or Time Zone.
19
• TV type (AUTO, PAL, NTSC). Select AUTO and
the SRT 5392 will determine the correct
setting for you.
• Channel Change Option (Freeze, Blank,
Fade In/Out). This option determines how the
screen transitions from one channel to the
next.
• Booster: (0V, 5V). Choose 5V if you have a
reception booster attached to your antenna
that does not have its own power supply.
(Most boosters already have a power
supply.)
or VOL to
or