Table of Contents
Advertisement
The system goes into sleep mode in the following situations:
[8] System Goes into the Sleep Mode
When
1
The job queue of the Océ VarioPrint
a defined time.
This time is defined in the Océ Settings Editor. The key
Note:
operator can set a time between 1 and 240 minutes in increments of
1 minute. The factory default is 90 minutes.
2
You press the On/Off button
[8] System Goes into the Sleep Mode
The system returns from the sleep mode in the following situations.
[9] System returns from the sleep mode
When
1
You press the On/Off button
2
An automatic print job (AP) arrives in the job queue.
When the automatic print job is forced to the mailbox (as
Note:
defined in the Océ Settings Editor), the system remains in the sleep
mode.
3
You send a print job (only when the setting 'Automatic wake-up' in
the Océ Settings Editor is enabled)
[9] System returns from the sleep mode
The system needs a couple of minutes to warm up.
Note:
Introduction
®
2100/2110 has been empty for
on the printer
on the printer
21
Advertisement
Table of Contents
