Table of Contents
Advertisement
Settings for
Settings
'Print '
'Exposure'
'Margin shift'
'Shift to cen-
ter'
[42] Settings for the Print
Offset stacked
The prints are collated in the finisher and ejected in sets into one of the output
trays. Select 'Offset stacked' to separate the different sets. If you set 'Offset
stacked' to 'Yes', each printed set is moved approximately 1 cm to separate the
set from the previous sets.
The Copy Function
Definition
You can adjust the settings for light areas
and dark areas on the print independently.
If an area on the print is light gray and you
want it to be white, move the cursor in the
'Light' bar to white.
If an area on the print is dark gray and you
want it to be black, move the cursor in the
'Dark' bar to black.
This setting indicates the image shift on the
front and the rear side of the print seen
from the binding edge (see 'Document
type').
This setting indicates that the image is put
into the center of the sheet.
145
Advertisement
Table of Contents
