Table of Contents
Advertisement
Example 20-14 shows that a virtual device called
Example 20-14 Virtual device tsm0 created
COMMAND STATUS
Command: OK
Before command completion, additional instructions may appear below.
Device tsm0 for TSM server lochness has been added.
Esc+1=Help
Esc+8=Image
n=Find Next
20.3.4 Configuring network boot options for BMR
In order to perform a Tivoli Storage Manager Bare Machine Recovery, the install
client must initiate a network boot in order to access the SysBack System
Installation & Maintenance Main Menus.
Network boot configuration procedures are performed like any other SysBack
network boot configuration. All of the same requirements apply, with the following
additional requirements:
When performing a SysBack Classic Network Boot, the Tivoli Storage
Manager 32-bit API client and the tivoli.tivguid (prerequisite of the API client)
filesets must be installed on to the network boot server.
When performing a SysBack NIM Resource Network Boot, the Tivoli Storage
Manager 32-bit API client and tivoli.tivguid (prerequisite of the API client)
filesets must be installed in to the NIM SPOT.
Note: There is no SysBack utility available for installing the Tivoli Storage
Manager filesets into the NIM SPOT. You must install them yourself using
standard NIM commands.
Optionally, you may choose to pre-configure the TSM Network Install Client
defaults to avoid the manual entry of these values in the SysBack Installation &
Maintenance Main Menus.
stdout: yes
Esc+2=Refresh
Esc+3=Cancel
Esc+9=Shell
Esc+0=Exit
Chapter 20. Bare Machine Recovery
tsm0
has been created.
stderr: no
Esc+6=Command
/=Find
675
Advertisement
Table of Contents
