Table of Contents
Advertisement
17.3 Configuration steps: Overview
Here is an overview of the steps you should follow to successfully configure
server-free data movement:
1. Set up the Storage Area Network.
2. Set up FAStT 500.
3. Set up IBM 3583. Make sure the tape library has the correct firmware level.
4. Install HBAs on the client and server machines. Install the correct device
driver and API for the HBAs. Refer to the requirements section for the level of
drivers and API.
5. Connect the client and server machines to the Fibre Switches.
6. Create zones as described in the setup section.
7. Install device drivers for IBM 3583 on the server machine.
8. Install the FAStT storage Manager on one of the machines to manage FAStT
500 Box.
9. Enable the SAN Data Gateway (datamover).
10.Set up the Tivoli Storage Manager Server.
11.Set up the Tivoli Storage Manager Client.
17.4 Setting up server-free data movement
Configuration for server-free data movement requires the steps described below.
We assume that you have knowledge about how to set up zoning and update
firmware for various SAN devices.
17.4.1 SAN configuration
The SAN should be configured correctly. We do not show you how to set up the
SAN, but we provide you with a view of the SAN after the setup.
570
IBM Tivoli Storage Manager Implementation Guide
Advertisement
Table of Contents
