Figure 3-8. Belt Block With Belt In Place - Compaq SW TL881 DLT Mini-Lib/1 Reference Manual

1

Figure 3-8. Belt block with belt in place

Belt Block with Belt in Place
Figure Legend
1
2
3
10. Tighten the four screws that hold the belt retaining plates.
11. Pull out the paper clip previously installed in the base section. This
applies the proper tension to the belt.
12. Locate the two captive screws in the car. Screw them backward one turn
to line them up and then screw them approximately one thread into the
bracket in the car so they are held in an upright position.
13. Position the belt block at least six inches from the motor drive pulley.
14. Locate the spring-loaded wheels of the car. Engage the spring-loaded
wheels in the track, while positioning the car so the captive screws are
directly over the holes in the belt block (Figure 3-9 and Table 3-6).
IMPORTANT: Figure 3-9 omits the door on the car for clarity. Do not remove the door.
2
Table 3-5
Description
Belt
Gap visible
Block
Installation 3-13
3
SHR-1708