Set Element Base - Compaq SW TL881 DLT Mini-Lib/1 Reference Manual

The following Special Config submenu appears:
Mode Pg 1F Length
* Short (0x0E)
Model Number
* Compaq TL89X
Press
the Enter button to move
change to Custom and press the Enter button to accept this setting. To
return the Base Module to online status, press the Escape button three
times.

Set Element Base

This option lets you set the base addresses of each of the three SCSI elements
of the module. In order to identify sources and destinations in commands to
the robotics, the Base Module is divided into elements, each of which is
assigned a separate designator or element address. The transport element is the
robotics mechanism itself; the storage elements are the 10 or 16 slots in the
magazine; the transfer elements are the drives. The Base Module reports these
settings in response to the SCSI MODE SENSE command, in the element
address assignment page. The defaults are transport = 0000h, storage element
base = 0001h, transfer element base = 00F0h.
twice to position the
down one line to *Standard. Use the
next to the TUR Reporting option. Press
Configuration 4-7
to