Figure 3-2. Ptm Car (Front View) - Compaq SW TL881 DLT Mini-Lib/1 Reference Manual

Installation 3-5
Follow the instructions in the section "Mechanical Installation of the
Expansion and Base Modules." After the rack slides and the Base Modules are
in place, and after the PTM is assembled, you will install the PTM in the rack
by attaching the support braces to the rear of the outer rail slides using the
angle brackets.
The internal parts you will need to recognize during assembly are shown in
Figures 3-2 and 3-3 (see Table 3-2).
SHR-1702

Figure 3-2. PTM car (front view)