Rapid Startup; San Connection Tool; Connecting To Ma With Acs 8.5 Or 8.6; Connecting To A Ma With Acs 8.7 - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Installation Manual

[Enter your Document Title]

Rapid Startup

SAN Connection
Tool
Open an Internet Explorer session and navigate to the WEBUI for StorageWorks NAS.
The WEBUI is accessible through the hostname and port 3201. For example
http://hostname:3201.
The Rapid Startup Utility is provided to allow a quick setup of the network connections.
The Rapid Startup Utility will be the first page displayed when the WEBUI is opened.
Rapid Startup will allow for the configuration of all network adapters and the Remote
Insight Board. The Rapid Start utility is accessible through the WEBUI.
1. Click on the Internet Explorer icon in the fast start tray. Navigate to
http://hostname:3201. A prompt for a username and password will appear.
The user name is administrator and there is no password. The password is the
same password that is used for the local administrator account on the server. So
if the password has been changed for the local administrator's account, then
that password must also be used to login into the WEBUI.
2. Complete the Rapid Startup by filling in the appropriate information in the fields
provided.
3. Once rapid start is complete the node will reboot.
NOTE: Make sure to do this on both nodes before continuing
The SAN Connection Tool is a utility which configures the nodes for connection to a
StorageWorks SAN. The SAN Connection tool is accessible through the WEBUI and
must be completed after the Rapid Startup utility. No Fiber cables should be connected
to the Node At this time and the nodes should remain unconnected until after the SAN
Connection Tool process is completed.
The e7000v1 supports EVA, MA and XP storage arrays.
From a remote client, click on the Internet Explorer icon in the fast start tray. Navigate to
http://hostname:3201. A prompt for a username and password will appear. The user
name is administrator, the password should be null if this is a new install (the password
is the same password that is used for the local administrator account on the server).
Verify that no fiber cables are connected to the HBA's.
Determine the type of storage array being used and follow the procedures below for that
storage array:

Connecting to MA with ACS 8.5 or 8.6

1. Run lputilnt.exe from a command prompt and verify that the HBA driver is 5-
4.81a9 and the firmware is 3.82a1
2. Run the SAN Connection Tool and select MA with ACS 8.5 or 8.6
3. Follow the instructions and complete the wizard
4. The SAN Connection Tool will install all components and reboot the Node
Automatically. The splash screen will confirm when the installation is complete.
5. Attach the Fiber cables.

Connecting to a MA with ACS 8.7

1. Run lputilnt.exe from a command prompt and verify that the HBA driver is 5-
[Document Restriction Notice]
5