Installing The Top Cover; Removing The Side Cover; Figure 2-15 Top Cover Detail - HP Integrity rx8640 Installation Manual

Installing the System
Installing the Top and Side Covers
Step 5. Place the cover in a safe location.
Figure 2-15 Top Cover Detail
Retaining Screws

Installing the Top Cover

The following section describes the procedure for installing the top cover.
Step 1. Orient the cover according to its position on the chassis.
Step 2. Slide the cover into position using a slow, firm pressure to properly seat the cover.
Step 3. Tighten the blue retaining screws securing the cover to the chassis.

Removing the Side Cover

The following section describes the procedure for removing the side cover.
Step 1. Connect to ground with a wrist strap.
57
Chapter 2