Removing And Replacing The System Board - HP ProLiant DL560 Gen10 Maintenance And Service Manual

• Extend the server from the rack (Extend the server from the rack on page 33).
• Remove the server from the rack (Removing the server from the rack on page 34).
4. Remove the access panel (Removing the access panel on page 35).
5. If installed, remove the secondary PCIe riser cage (Removing and replacing a PCIe riser cage on page
51).
6. Locate the battery (System board components on page 90).
7. Remove the battery.
8. To replace the component, reverse the removal procedure.
9. Properly dispose of the old battery.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

Removing and replacing the system board

Procedure
1. Power down the server (Power down the server on page 33).
2. Remove all power.
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 33).
• Remove the server from the rack (Removing the server from the rack on page 34).
4. Remove the access panel (Removing the access panel on page 35).
5. If installed, do the following:
68 Removing and replacing the system board