Mirroring-Group Monitor-Port (System View) - HP 6125XLG Command Reference Manual

[Sysname] interface ten-gigabitethernet 1/1/6
[Sysname-Ten-GigabitEthernet1/1/6] mirroring-group 2 monitor-port
Related commands
mirroring-group

mirroring-group monitor-port (system view)

Use mirroring-group monitor-port to configure a port as the monitor port for a mirroring group.
Use undo mirroring-group monitor-port to remove the monitor port from a mirroring group.
Syntax
mirroring-group group-id monitor-port interface-type interface-number
undo mirroring-group group-id monitor-port interface-type interface-number
Default
No monitor port is configured for a mirroring group.
Views
System view
Predefined user roles
network-admin
Parameters
group-id: Number of the mirroring group, in the range of 1 to 4. The mirroring group specified by
group-id must already exist.
interface-type interface-number: Specifies a port to be configured as the monitor port by its type and
number.
Usage guidelines
You can configure a monitor port only for a local mirroring group or remote destination group, but not
for a remote source group.
Do not enable the spanning tree feature on the monitor port.
When an aggregate interface is configured as the monitor port, do not configure its member ports as
source ports.
Use a monitor port only for port mirroring to make sure the data monitoring device receives and analyzes
only the mirrored traffic rather than a mix of mirrored traffic and normally forwarded traffic.
Do not configure a port of an existing mirroring group as the monitor port.
Examples
# Create local mirroring group 1, and configure port Ten-GigabitEthernet 1/1/5 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
[Sysname] mirroring-group 1 monitor-port ten-gigabitethernet 1/1/5
# Create remote destination group 2, and configure port Ten-GigabitEthernet 1/1/6 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-destination
195