NTP commands
display ntp-service ipv6 sessions
Use display ntp-service ipv6 sessions to display information about all IPv6 NTP associations.
Syntax
display ntp-service ipv6 sessions [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
verbose: Displays detailed information about all IPv6 NTP associations. If you do not specify this
keyword, the command displays only brief information about the IPv6 NTP associations.
Examples
# Display brief information about all IPv6 NTP associations.
<Sysname> display ntp-service ipv6 sessions
Notes: 1 source(master), 2 source(peer), 3 selected, 4 candidate, 5 configured.
Source:
Reference: 127.127.1.0
Reachabilities: 1
Last receive time: 6
Roundtrip delay: 0.0
Total sessions : 1
Table 5 Command output
Field
[12345]
Source
[125]3000::32
Description
•
1—Clock source selected by the system (the current reference source). It has
a system clock stratum level less than or equal to 15.
•
2—The stratum level of the clock source is less than or equal to 15.
•
3—The clock source has survived the clock selection algorithm.
•
4—The clock source is a candidate clock source.
•
5—The clock source was created by a command.
IPv6 address of the NTP server.
Clock stratum: 2
Poll interval: 64
Offset: -0.0
Dispersion: 0.0
15