Configuring An Ike-Based Ipsec Tunnel For Ipv4 Packets - HP 6125XLG Configuration Manual

[SwitchB-ipsec-policy-manual-use1-10] sa string-key inbound esp simple abcdefg
[SwitchB-ipsec-policy-manual-use1-10] quit
# Apply the IPsec policy use1 to interface VLAN-interface 1.
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ipsec policy use1
Verifying the configuration
After the previous configurations, an IPsec tunnel between Switch A and Switch B is established, and the
traffic between the switches is IPsec protected.
Use the display ipsec sa command to display IPsec SAs on Switch A and Switch B. This example uses
Switch A.
[SwitchA] display ipsec sa
-------------------------------
Interface: Vlan-interface 1
-------------------------------
-----------------------------
IPsec policy: map1
Sequence number: 10
Mode: manual
-----------------------------
Tunnel id: 549
Encapsulation mode: tunnel
Path MTU: 1443
Tunnel:
local
remote address: 2.2.3.1
Flow:
as defined in ACL 3101
[Inbound ESP SA]
SPI: 54321 (0x0000d431)
Transform set: ESP-ENCRYPT-AES-CBC-192 ESP-AUTH-SHA1
No duration limit for this SA
[Outbound ESP SA]
SPI: 12345 (0x00003039)
Transform set: ESP-ENCRYPT-AES-CBC-192 ESP-AUTH-SHA1
No duration limit for this SA

Configuring an IKE-based IPsec tunnel for IPv4 packets

Network requirements
As shown in
between the switches. Configure the IPsec tunnel as follows:
Specify the encapsulation mode as tunnel, the security protocol as ESP, the encryption algorithm as
•
AES-CBC- 1 92, and the authentication algorithm as HMAC-SHA1.
• Set up SAs through IKE negotiation.
address: 2.2.2.1
Figure 74, establish an IPsec tunnel between Switch A and Switch B to protect data flows
218