Configuring Isp Domain Status; Configuring Authentication Methods For An Isp Domain - HP 6125XLG Configuration Manual

Configuring ISP domain status

By placing the ISP domain to the active or blocked state, you allow or deny network service requests from
users in the domain.
The ISP domain status applies to all users in the domain.
To configure the ISP domain status:
Step
1. Enter system view.
2. Enter ISP domain view.
3. Place the ISP domain in active
or blocked state.

Configuring authentication methods for an ISP domain

Configuration prerequisites
Before configuring authentication methods, complete the following tasks:
1. Determine the access type or service type to be configured. With AAA, you can configure an
authentication method for each access type and service type.
Determine whether to configure the default authentication method for all access types or service
2.
types. The default authentication method applies to all access users, but it has a lower priority than
the authentication method that is specified for an access type or service type.
Configuration guidelines
When configuring authentication methods, follow these guidelines:
If you configure an authentication method that references a RADIUS scheme and an authorization
•
method that does not reference a RADIUS scheme, AAA accepts only the authentication result from
the RADIUS server. The Access-Accept message from the RADIUS server also includes the
authorization information, but the device ignores the information.
To specify a scheme for user role authentication, make sure the user role is in the format of level-n.
•
If an HWTACACS scheme is specified, the device uses the entered username for role authentication.
If a RADIUS scheme is specified, the device uses the username $enabn$ on the RADIUS server for
role authentication, where n is the same as that in the target user role level-n.
Configuration procedure
To configure authentication methods for an ISP domain:
Step
1. Enter system view.
2. Enter ISP domain view.
Command
system-view
domain isp-name
state { active | block }
Command
system-view
domain isp-name
41
Remarks
N/A
N/A
By default, an ISP domain is in active state,
and users in the domain can request
network services.
Remarks
N/A
N/A