Download Print this page

HP 6125XLG Configuration Manual: Ipsec Sa Negotiation Failed Due To Invalid Identity Information

R2306-hp 6125xlg blade switch security configuration guide.
Hide thumbs

Advertisement

Analysis
Certain IPsec policy settings are incorrect.
Solution
1.
Examine the IPsec configuration to see whether the two ends have matching IPsec transform sets.
2.
Modify the IPsec configuration to make sure the two ends have matching IPsec transform sets.

IPsec SA negotiation failed due to invalid identity information

Symptom
The display ike sa command shows that the IKE SA negotiation succeeded and the IKE SA is in RD
1.
state, but the display ipsec sa command shows that the expected IPsec SA has not been negotiated
yet.
2.
The following IKE debugging message appeared:
Notification INVALID_ID_INFORMATION is received.
Or:
Failed to get IPsec policy when renegotiating IPsec SA. Delete IPsec SA.
Construct notification packet: INVALID_ID_INFORMATION.
Analysis
Certain IPsec policy settings of the responder are incorrect. Verify the settings as follows:
1.
Use the display ike sa verbose command to verify that matching IKE profiles were found in IKE
negotiation phase 1. If no matching IKE profiles were found and the IPsec policy is referencing an
IKE profile, the IPsec SA negotiation fails.
# Verify that matching IKE profiles were found in IKE negotiation phase 1.
<Sysname> display ike sa verbose
-----------------------------------------------
Connection ID: 3
Outside VPN:
Inside VPN:
Profile:
Transmitting entity: Responder
-----------------------------------------------
Local IP: 192.168.222.5
Local ID type: IPV4_ADDR
Local ID: 192.168.222.5
Remote IP: 192.168.222.71
Remote ID type: IPV4_ADDR
Remote ID: 192.168.222.71
Authentication-method: PRE-SHARED-KEY
Authentication-algorithm: MD5
Encryption-algorithm: 3DES-CBC
Life duration(sec): 86400
Remaining key duration(sec): 85847
237

Advertisement

Troubleshooting

   Related Manuals for HP 6125XLG

Comments to this Manuals

Symbols: 0
Latest comments: