Download Print this page

HP 6125XLG Configuration Manual: Configuration Procedure; Configuration Example

R2306-hp 6125xlg blade switch security configuration guide.
Hide thumbs

Advertisement

Do not configure both the arp filter source and arp filter binding commands on an interface.
If ARP filtering works with ARP detection and ARP snooping, ARP filtering applies first.

Configuration procedure

To configure ARP filtering:
Step
1.
Enter system view.
2.
Enter Ethernet interface or
aggregate interface view.
3.
Enable ARP filtering and
configure a permitted entry.

Configuration example

Network requirements
As shown in
respectively. The IP and MAC addresses of Host B are 10.1.1.3 and 000f-e349- 1 234.
Configure ARP filtering on Ten-GigabitEthernet 1/1/5 and Ten-GigabitEthernet 1/1/6 of Switch B to
permit ARP packets from the two hosts only.
Figure 65 Network diagram
Configuration procedure
# Configure ARP filtering on Switch B.
<SwitchB> system-view
[SwitchB] interface ten-gigabitethernet 1/1/5
[SwitchB-Ten-GigabitEthernet1/1/5] arp filter binding 10.1.1.2 000f-e349-1233
[SwitchB-Ten-GigabitEthernet1/1/5] quit
[SwitchB] interface ten-gigabitethernet 1/1/6
Command
system-view
interface interface-type interface-number
arp filter binding ip-address
mac-address
Figure
65, the IP and MAC addresses of Host A are 10.1.1.2 and 000f-e349- 1 233
184
Remarks
N/A
N/A
By default, ARP filtering is
disabled.

Advertisement

Troubleshooting

   Related Manuals for HP 6125XLG

Comments to this Manuals

Symbols: 0
Latest comments: