HP 6125XLG Configuration Manual page 230

Blade switch security configuration guide
Table of Contents

Advertisement

[SwitchB-ipsec-policy-isakmp-use1-10] security acl 3101
# Apply the IPsec transform set tran1.
[SwitchB-ipsec-policy-isakmp-use1-10] transform-set tran1
# Specify the local and remote IP addresses of the IPsec tunnel as 2.2.3.1 and 2.2.2.1.
[SwitchB-ipsec-policy-manual-map1-10] local-address 2.2.3.1
[SwitchB-ipsec-policy-manual-use1-10] remote-address 2.2.2.1
# Apply the IKE profile profile1.
[SwitchB-ipsec-policy-isakmp-use1-10] ike-profile profile1
[SwitchB-ipsec-policy-isakmp-use1-10] quit
# Apply the IPsec policy use1 to interface VLAN-interface 1.
[SwitchB] interface vlan-interface 1
[SwitchB-Vlan-interface1] ipsec policy use1
Verifying the configuration
After the previous configurations, IKE negotiation is triggered to set up IPsec SAs when there are
end-to-end packets between Switch A and Switch B. After IPsec SAs are successfully negotiated by IKE,
the traffic between the two switches is IPsec protected.
221

Advertisement

Table of Contents
loading

Table of Contents