HP 6125XLG Configuration Manual page 109

[Device] display domain sun
Domain:sun
State: Active
Access-limit: Disabled
Access-Count: 0
lan-access Authentication Scheme:
lan-access Authorization
lan-access Accounting
default Authentication Scheme:
default Authorization
default Accounting
# Display the port security configuration.
[Device] display port-security interface ten-gigabitethernet 1/1/5
Port security is enabled globally
AutoLearn aging time is 0 minutes
Disableport Timeout: 20s
OUI value:
Index is 1, OUI value is 123401
Index is 2, OUI value is 123402
Index is 3, OUI value is 123403
Index is 4, OUI value is 123404
Index is 5, OUI value is 123405
Ten-GigabitEthernet1/1/5 is link-up
Port mode : userLoginWithOUI
NeedToKnow mode: Disabled
Intrusion protection mode: NoAction
Max number of secure MAC addresses: Not configured
Current number of secure MAC addresses: 1
Authorization is permitted
After an 802.1X user goes online, you can see that the number of secure MAC addresses saved by the
port is 1. You can use the display dot1x command to display information about online 802.1X users.
The port also allows one user whose MAC address has an OUI among the specified OUIs to pass
authentication. You can use the following command to display the MAC address information for the port:
[Device] display mac-address interface ten-gigabitethernet 1/1/5
MAC Address VLAN ID
1234-0300-0011 1
radius: radsun
Scheme: radius: radsun
Scheme: radius: radsun
local
Scheme: local
Scheme: local
State Port/NickName
Learned Ten-GigabitEthernet1/1/5
100
Aging
Y