Configuration File - HP 6125XLG Configuration Manual

[Sysname] fips mode enable
This command enables FIPS mode and requires a device reboot, are you sure? [Y/N]:y
Reboot the device automatically to enter FIPS mode? [Y/N]:n
Prepare and save all configurations for FIPS mode in the startup configuration file, and
then reboot the device.
# Save the current configuration to the root directory of the storage medium, and specify it as the startup

configuration file.

[Sysname] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[Sysname] quit
# Delete the startup configuration file in binary format.
<Sysname> delete flash:/startup.mdb
Delete flash:/startup.mdb?[Y/N]:y
Deleting file flash:/startup.mdb...Done.
# Reboot the device.
<Sysname> reboot
Verifying the configuration
After the device reboots, enter the username test and the password 12345zxcvb!@#$%ZXCVB. The
system prompts you to configure a new password. After the new password is set, the device enters FIPS
mode. The new password must be different from the old one, must include at least 15 characters, and
must contain uppercase and lowercase letters, digits, and special characters. For more information about
the requirements for the password, see the displayed information.
Press ENTER to get started.
login: test
Password:
First login or password reset. For security reason, you need to change your pass
word. Please enter your password.
old password:
new password:
confirm:
Updating user information. Please wait ... ...
...
<Sysname>
# Display the current FIPS mode state.
<Sysname> display fips status
FIPS mode is enabled.
197