Feature
Port security
IP source guard
802.1X
•
If a port is used as a reflector port for port mirroring, do not assign it to an aggregation group. For
more information about reflector ports, see Network Management and Monitoring Configuration
Guide.
You can assign the following ports to an aggregation group: monitor ports for port mirroring, ports
•
configured with static MAC addresses, or ports configured with MAC address learning limit.
Removing an aggregate interface also removes the corresponding aggregation group. At the same
•
time, all member ports leave the aggregation group.
Configuring a static aggregation group
To guarantee a successful static aggregation, make sure that the ports at both ends of each link are in the
same aggregation state.
Configuring a Layer 2 static aggregation group
Step
1.
Enter system view.
2.
Create a Layer 2
aggregate interface and
enter Layer 2 aggregate
interface view.
3.
Exit to system view.
4.
Assign an Ethernet
interface to the
aggregation group.
5.
Assign the port an
aggregation priority.
Reference
Port security in Security Configuration Guide
IP source guard in Security Configuration Guide
802.1X in Security Configuration Guide
Command
system-view
interface bridge-aggregation
interface-number
quit
a.
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
b.
Assign the Ethernet interface
to the aggregation group:
port link-aggregation group
number
link-aggregation port-priority
port-priority
36
Remarks
N/A
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2 static
aggregation group numbered the
same.
N/A
Repeat this step to assign more Layer
2 Ethernet interfaces to the
aggregation group.
Optional.
By default, the aggregation priority
of a port is 32768.
Changing the aggregation priority of
a port might affect the aggregation
state of the ports in the static
aggregation group.