Configuration Restrictions And Guidelines; Configuration Procedure - HP 6125G Configuration Manual

Figure 70 Setting the state of each member port in a service loopback group
NOTE:
Every time a new port is assigned to a service loopback group, the system resets the state of the member
ports in the service loopback group according to the process described previously.

Configuration restrictions and guidelines

• A service loopback group may be referenced by multiple features once it is created, and can
process service traffic only after it is referenced.
You can change the service type of an existing service loopback group. For the change to be
•
successful, make sure that the service group has not been referenced, the attributes of all member
ports (if any) do not conflict with the target service type, and no service loopback group has been
created for the target service type, because only one service loopback group is allowed for a
service type.
• You cannot remove a service loopback group that other features reference.

Configuration procedure

Step
1. Enter system view.
2. Create a service
loopback group and
specify its service
type.
3. Enter Layer 2 Ethernet
interface view.
Command
system-view
service-loopback group number
type tunnel
interface interface-type
interface-number
213
Remarks
N/A
N/A
N/A