Configuration procedure
To set a port to operate in automatic voice VLAN assignment mode:
Step
1.
Enter system view.
2.
Set the voice VLAN aging
time.
3.
Enable the voice VLAN
security mode.
4.
Add a recognizable OUI
address.
5.
Enter Layer 2 Ethernet
interface view.
6.
Configure the link type of the
Ethernet interface.
7.
Configure the port to operate
in automatic voice VLAN
assignment mode.
8.
Enable the voice VLAN
feature.
Configuring a port to operate in manual voice
VLAN assignment mode
Configuration restrictions and guidelines
•
You can configure different voice VLANs on different ports at the same time. However, you can
configure one port with only one voice VLAN, and this voice VLAN must be a static VLAN that
already exists on the device.
You cannot enable voice VLAN on the member ports of a link aggregation group. For more
•
information about the member ports, see
Command
system-view
voice vlan aging minutes
voice vlan security enable
voice vlan mac-address oui mask
oui-mask [ description text ]
interface interface-type
interface-number
•
port link-type trunk
•
port link-type hybrid
voice vlan mode auto
voice vlan vlan-id enable
"Configuring Ethernet link
136
Remarks
N/A
Optional.
By default, the aging time of a
voice VLAN is 1440 minutes.
The voice VLAN aging time
configuration is only applicable on
ports in automatic voice VLAN
assignment mode.
Optional.
By default, the voice VLAN security
mode is enabled.
Optional.
By default, each voice VLAN has
default OUI addresses configured.
For the default OUI addresses of
different vendors, see
Table
N/A
Use one of the commands.
Optional.
By default, the automatic voice
VLAN assignment mode is
enabled.
The voice VLAN assignment modes
on different ports are independent
of one another.
By default, the voice VLAN feature
is disabled.
aggregation."
14.