Digest Snooping Configuration Example - HP 6125G Configuration Manual

Step
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
3. Enable Digest Snooping on
the interface.
4. Return to system view.
5. Enable global Digest
Snooping.

Digest Snooping configuration example

Network requirements
As shown in
Device A and Device B connect to Device C, which is a third-party device. All these devices are in
•
the same region.
• Enable Digest Snooping on the ports of Device A and Device B that connect to Device C, so that the
three devices can communicate with one another.
Figure 18 Network diagram
Configuration procedure
# Enable Digest Snooping on GigabitEthernet 1/0/1 of Device A and enable global Digest
Snooping on Device A.
<DeviceA> system-view
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] stp config-digest-snooping
[DeviceA-GigabitEthernet1/0/1] quit
Figure 18:
Command
interface interface-type
interface-number
stp config-digest-snooping
quit
stp config-digest-snooping
80
Remarks
N/A
Disabled by default.
N/A
Disabled by default.