Configuring The Garp Timers - HP 6125G Configuration Manual

Step
5. Assign the trunk ports to
all VLANs.
6. Enable GVRP on the
ports.
7. Configure the GVRP
registration mode on the
port.

Configuring the GARP timers

Step
1. Enter system view.
2. Configure the GARP
LeaveAll timer.
3. Enter Ethernet interface view
or Layer 2 aggregate
interface view.
4. Configure the Hold timer.
5. Configure the Join timer.
6. Configure the Leave timer.
As shown in
guidelines to configure GARP timers:
If you want to set a value beyond the value range for a timer, you can change the value range by
•
tuning the value of another related timer.
• If you want to restore the default settings of the timers, restore the Hold timer first, followed by the
Join, Leave, and LeaveAll timers.
Table 19 Dependencies of the GARP timers
Timer
Hold
Join
Command
port trunk permit vlan all
gvrp
gvrp registration { fixed | forbidden |
normal }
Command
system-view
garp timer leaveall timer-value
interface interface-type
interface-number
garp timer hold timer-value
garp timer join timer-value
garp timer leave timer-value
Table 19, the value ranges for GARP timers are dependent on one another; use the following
Lower limit
10 centiseconds
No less than twice the Hold timer
Upper limit
No greater than half of the Join timer
Less than half of the Leave timer
147
Remarks
By default, a trunk port is
assigned to VLAN 1 only.
For more information about the
port trunk permit vlan all
command, see Layer 2—LAN
Switching Command Reference.
Disabled by default.
Optional.
normal by default.
Remarks
N/A
Optional.
1000 centiseconds by default.
The LeaveAll timer applies to all
ports.
N/A
Optional.
10 centiseconds by default.
Optional.
20 centiseconds by default.
Optional.
60 centiseconds by default.