Preparing - Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining

Rack Mounting the Tape Library

Preparing

3.5.1
Before installing the library:
● Make sure that the host bus adapter card installed in the host computer, any
necessary device drivers, and your backup software are compatible with the
library. Make certain that an any necessary drivers installed in the host
computer are compatible with the tape drive in a library.
You can install the software on the host computer before or after library
●
installation. However, if you install the software first, you may need to recon-
figure it for use with the library after library installation is complete.
The library must be operated in the horizontal position. Do not place the
●
library on its side, and do not place objects on top of the library.
V
CAUTION
Before performing any installation or maintenance procedures, be sure
that the library power switch is in the off position and that the power cord
is disconnected from the library and the outlet.
22
Installing the Tape Library
ETERNUS LT20 S2