Input Modes; Selectable Predefined Values; Toggle Values; Numerical Values - Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining

Operating the LTO Library
initialization is complete, the Ready/Activity LED will stop flashing and be
constantly illuminated. The Magazine Status LEDs will also show the appro-
priate status (locked, unlocked or removed).
If a library failure occurs, the Ready/Activity LED will be turned off and the Error
LED will be illuminated. The OCP will also display an appropriate error code to
help identify the failure.
4.1.5

Input Modes

There are several modes to enter values in the different menu items. These
values are selectable predefined values, toggle values (e.g. On/Off) and
numerical values like network addresses.
4.1.5.1

Selectable Predefined Values

After navigating to the menu item the various predefined values can be selected
with the (▲) and (▼) key. As soon as the display shows the correct value it will
be entered by pressing the ENTER key.
4.1.5.2

Toggle Values

Toggle values are used to switch between two different states like On and Off.
After navigating to the menu item the display shows the actual state. Pressing
the ENTER button will switch to the possible new state. Pressing ENTER a
second time will take over this new state. This procedure works vice-versa.
4.1.5.3

Numerical Values

Numerical values are needed for network addresses, PIN entries and other
configuration entries. After navigating to the menu item which should be
changed the actual value will be displayed and the cursor stays on the first digit.
The value can be incremented/decremented with the (▲) and (▼) button. After
pressing the ENTER button the cursor is set to the next editable digit. It can be
changed in the same way. After pressing the ENTER button at the last digit the
complete entry will be stored. Pressing the CANCEL button will cancel the
whole edit process and the old value is valid again.
ETERNUS LT20 S2
Operator Control Panel (OCP)
37