Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining page 24

Rack Mounting the Tape Library
1. If you use a Fujitsu Technology Solutions PRIMECENTER rack you first have
to mount the support bracket in the appropriate height to the - seen from the
front of the rack - left rear rack post as shown below.
Figure 11: Mounted support bracket
2. Mount a cage nut at the appropriate height to the right and left rack post
each. Mount them in the middle square hole of the height unit in which you
mounted the support bracket. (The middle of a height unit is the hole
between two wide and neighboring division bars.)
Height unit no. 26
Figure 12: Mounting cage nuts at the front of the rack (PRIMECENTER rack)
24
Installing the Tape Library
ETERNUS LT20 S2