Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining page 101

Servicing
Figure 74: Tape drive removal
To replace a tape drive:
1. Before installing the new drive inspect the connectors on the tape drive.
Ensure that the connectors are intact, free of any foreign objects, and have
no cracks or deformed or bent contacts.
2. Slowly insert the new tape drive into the drive bay, and align the connectors
on the library while supporting the drive assembly (see figure 75).
3. Push the Product ID tag slide down slightly to prevent damage.
Figure 75: Installing a tape drive
4. Push the tape drive slowly into the drive bay until the drive seats itself
against the back of the library.
5. Push the Product ID tag slide back underneath the drive sled. When inserted
properly, only the handle of the slide will be visible.
6. Tighten the captive thumbscrews until the drive is secure.
7. Connecting the power cable and terminator.
8. Power on the library using the power button on the front panel.
Run the library Verify test.
ETERNUS LT20 S2
Removing and Replacing a Tape Drive
101