Rack Mounting The Library; Preparing - Fujitsu ETERNUS LT40 S2 Installing, Starting Up And Maintaining

Chapter 2 Installing the Tape Library

2.5 Rack Mounting the Library

2.5 Rack Mounting the Library
WARNING
2.5.1

Preparing

Before installing the library:
• Make sure that the host bus adapter card installed in the host computer, any necessary device drivers, and
your backup software are compatible with the library. Make certain that an any necessary drivers installed
in the host computer are compatible with the tape drive in a library.
• You can install the software on the host computer before or after library installation. However, if you install
the software first, you may need to reconfigure it for use with the library after library installation is
complete.
• The library must be operated in the horizontal position. Do not place the library on its side, and do not
place objects on top of the library.
CAUTION
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Weight!
Risk of personal injury or damage to the loader.
• Always remove all tapes to reduce the overall weight of the loader.
• Obtain adequate assistance to lift and stabilize the library during installation or
removal.
• Observe local health and safety requirements and guidelines for manual
material handling.
Before performing any installation or maintenance procedures, be sure that the
library power switch is in the off position and that the power cord is disconnected
from the library and the outlet.
26
Copyright 2018 FUJITSU LIMITED P3AM-5392-07ENZ0