Changing The Administrative Password - Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining

Operating the LTO Library
– IPv4 / IPv6 Target 2
– IPv4 / IPv6 Target 3
– IPv6 Community Name
– IPv6 Security User Name
– IPv6 SNMP Trap Notification Filter
Figure 51: Configuration, SNMP page
4.4.6.5

Changing the Administrative Password

This page allows the user to add and modify user accounts. You can reach this
page by selecting Configuration → User.
– Access Level – choose from 1 (Standard), 2 (Admin), or 3 (Service)
– Access Level Name – the name associated with the chosen Access Level
– New Password – the password can be a maximum of ten characters
– Repeat Password – enter the new password again
– OCP Access PIN Enabled – select this item, if you would like the Operator
Control Panel display to be password protected
– OCP Access PIN Code – the password for accessing the OCP when the
OCP Access PIN is enabled
– Repeat OCP Access PIN Code – enter the OCP Access PIN Code again
– Support Name – the name of the individual within your company to contact
for RMU or library support
ETERNUS LT20 S2
Remote Management Unit (RMU)
67