Unpacking The Lto Library - Fujitsu ETERNUS LT20 S2 Installing, Starting Up And Maintaining

Unpacking the LTO Library

3.2 Unpacking the LTO Library
Before you begin, clear a work surface to unpack the library. Select an open 1U
rack location allowing easy access to the host server and an easily accessible
power outlet.
I
If the temperature in the room where the library will be installed varies by
15º C (30º F) from the room where the library was stored, allow the library
to acclimate to the surrounding environment for at least 12 hours before
unpacking it from the shipping container.
Unpacking the library:
1. Before opening and removing the library from the box, inspect the container
for shipping damage. If you notice any damage, report it to the shipping
company immediately.
2. Open the box.
3. Remove the accessory package (if present) and set aside. Carefully remove
the shipping materials from the top of the library (see figure 6).
4. Remove the two rack rails (if included) and set aside.
5. Lift the library out of the carton and remove the bag from the library. Save
the packaging materials for future use.
V
CAUTION
Do not place the library on either end or sides as this may damage the
library.
I
After unpacking the library, save all the original packing materials in case
you need to ship or move the library later.
18
Installing the Tape Library
ETERNUS LT20 S2