Clear A Paper Jam Between The Receiver Unit And The Postfuser - Oce CPS700 Maintenance Manual

Clear a paper jam between the receiver unit and the postfuser

Introduction
This chapter describes how the key operator can clear a paper jam between the
receiver unit and the postfuser. A sheet of paper can be stuck between the
receiver unit and the paper inlet guide of the postfuser. When you open the
Central Process Group, the paper can tear into two parts. One part is in the
receiver unit. The other part is in the paper inlet guide of the postfuser. You
can remove the receiver unit and the paper inlet guide.
The procedure describes how the key operator can clear a paper jam. The paper
jams can be the following.
The paper is stuck in the receiver unit.
The paper is torn into two parts. One part is in the receiver unit. The other
part is in the paper inlet guide of the postfuser (see 'Clear a paper jam in
the postfuser' on page 105).
Note Attention Caution
Attention:
damage the parts of the Central Process Group.
Caution:
parts can be hot.
General procedure
Attention:
Open the front door.
1
Open the Central Process Group.
2
If necessary, remove the receiver unit.
3
Put the receiver unit back.
4
Close the Central Process Group.
5
Close the front door.
6
The system maintenance
Do not use sharp objects to remove the paper. Sharp objects can
Do not touch the other parts of the Central Process Group. The
Take the actions in the described order.
93