Access The Kos Editor - Oce CPS700 Maintenance Manual

Access the KOS editor

Introduction
The key operator can change the default settings of the Océ CPS700 to adjust
the system to the requirements. The key operator can change the settings on the
operator panel. The key operator can only access the 'KOS editor' if the Océ
CPS700 does not process a job.
Before you begin
Press the key for 'System manager'.
1
Press the key for 'System'.
2
Press the key for 'KOS editor'.
3
Enter the key operator PIN code.
4
Note Attention Caution
Note: All the settings become active when you leave a group of settings or the
KOS editor.
Illustration
[1] Change the workflow settings
[1] Change the workflow settings
12 Océ CPS700 Configuration and maintenance manual