Oce CPS700 Maintenance Manual page 50

Lift the lever on the right-hand side.
4
Pull the intermediate cleaner on the right-hand side a little bit out of the frame
5
of the clean unit.
Remove the intermediate cleaner.
6
How to install a new intermediate cleaner
Take a new intermediate cleaner.
1
Note: Do not yet remove the protective sheet.
Push the intermediate cleaner into the frame of the clean unit. Make sure that
2
the notches fit into the holes in the frame of the clean unit.
Check that the levers on the left-hand side and right-hand side click the
3
intermediate cleaner in the correct position.
Connect the connectors on both sides of the intermediate cleaner.
4
Remove the protective sheet from the intermediate cleaner.
5
How to put the receiver unit back
Put the receiver unit back. Make sure that the shafts fit into the holes. The teeth
1
of the gears on the right-hand side must grab into each other.
Push the lever of the receiver unit down to fasten the unit.
2
Note: When you put the receiver unit into the clean unit, make sure that the
receiver unit is correctly put into the holes. Otherwise the receiver unit and the
postfuser can get damaged.
50 Océ CPS700 Configuration and maintenance manual