Cisco 7945G Administration Manual page 173

Chapter 9 Troubleshooting and Maintenance
Table 9-2
Summary
Phone call cannot be
established
Call established with the iLBC
protocol does not show that the
iLBC codec is being used
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17755-01
Cisco Unified IP Phone Troubleshooting (continued)
Explanation
The phone does not have a DHCP IP address, is unable to register to
Cisco Unified Communications Manager, and shows a Configuring
IP or Registering message.
Verify the following:
The Ethernet cable is attached.
1.
The Cisco CallManager service is running on the Cisco Unified
2.
Communications Manager server.
Both phones are registered to the same Cisco Unified
3.
Communications Manager.
4. Audio server debug and capture logs are enabled for both
phones. If needed, enable Java debug.
Call statistics display does not show iLBC as the receiver/sender
codec.
1. Check the following by using Cisco Unified Communications
Manager Administration:
–
–
–
2. Capture a sniffer trace between the phone and Cisco Unified
Communications Manager and verify that SCCP messages,
OpenReceiveChannel, and StationMediaTransmit messages
have media payload type value equal to 86. If so, the problem is
with the phone; otherwise, the problem is with the Cisco Unified
Communications Manager configuration.
Enable audio server debug and capture logs from both phones. If
3.
needed, enable Java debug.
Both phones are in the iLBC device pool.
The iLBC device pool is configured with the iLBC region.
The iLBC region is configured with the iLBC codec.
General Troubleshooting Tips
9-13