Cisco 7945G Administration Manual page 113

Chapter 5 Configuring Features, Templates, Services, and Users
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description
Intercom Allows users to place and receive intercom calls using
programmable phone buttons. You can configure
intercom line buttons to:
•
•
Note
Join/Select Creates a conference by joining together existing calls
that are on a single phone line.
Join Across Lines Allows users to apply the Join feature to calls that are on
multiple phone lines.
(SCCP phones
only)
Line select If this feature is disabled (default), then the ringing line
is selected. When enabled, the primary line is picked up
even if a call is ringing on another line. The user must
manually select the other line.
Note
Line select for When disabled (default), pressing the Messages button
voice messages selects the line that has a voice message. If more than
one line has voice mail, then the first available line is
selected. When enabled, the primary line is always used
to retrieve voice messages.
Note
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.1(3)
OL-17755-01
Directly dial a specific intercom extension.
Initiate an intercom call and then prompt the user to
enter a valid intercom number.
If your user logs into the same phone on a daily
basis using their Cisco Extension Mobility
profile, assign the phone button template that
contains intercom information to their profile,
and assign the phone as the default intercom
device for the intercom line.
This feature can also be enabled or disabled for
Extension Mobility.
This feature can also be enabled or disabled for
Extension Mobility.
Telephony Features Available for the Phone
Configuration Reference
Cisco Unified CallManager Feature and
•
Services Guide, "Intercom chapter"
Cisco Unified CallManager Feature and
•
Services Guide, "Cisco Extension
Mobility" chapter
For more information, refer to Cisco
Unified IP Phone Guide, "Basic Call
Handling" chapter, "Making Conference
Calls" section.
For more information:
See the "Configuring Softkey
•
Templates" section on page
Refer to Cisco Unified Communications
Manager System Guide, "Cisco Unified IP
Phones" chapter.
For more information, refer to the option
"Always use prime line" in the following
chapters of Cisco Unified Communications
Manager Administration Guide:
"Device Profile Configuration Settings"
•
"Common Phone Profile Configuration
•
Settings"
"Phone Configuration Settings"
•
For more information, refer to the option
"Always use prime line for voice message" in
the following chapters of Cisco Unified
Communications Manager Administration
Guide:
"Device Profile Configuration Settings"
•
"Common Phone Profile Configuration
•
Settings"
"Phone Configuration Settings"
•
5-18.
5-9