Table of Contents
Advertisement
Off-line folding settings (optional)
Introduction
The default values for off-line folding are set in the Océ TDS700 Power Logic
controller application by the key operator. You can change these default values for
an off-line folding job on the printer operator panel. The settings include defining
the length and width of the folded package, enabling and defining the binding edge,
selecting the input method and legend position and cleaning the reinforcement knife.
After the folding job is completed the adjusted values return to their defaults.
Illustration
[12]
[12] Set off-line folding
Make off-line folding settings
Press the on-line key on the printer operator panel to put the printer off-line. The
1.
message Off-line is displayed in the status window.
Activate the Folding option by pressing the left selection key. The dotted line
2.
around the current selection is changed into an uninterrupted line and the small
selection triangles next to the specified option are no longer dimmed.
Use the Up / down keys to switch between the available options.
3.
Activate the Input option and press the right selection key to activate the Legend
4.
option.
If necessary, change the value in the Legend field with the Up / down keys.
5.
Press the right selection key again to activate the Method option.
6.
If necessary, change the value in the Width field with the Up / down keys.
7.
Press the left selection key again and use the Up / down keys to select another
8.
option. This can be Package (with optional Length and Width), Binding (with
optional Size and Binding), or Special (with optional Knife).
Feed the original at the back of the folder on the input table to start the off-line
9.
folding job.
Result
When the job is completed the settings on the printer operator panel return to the
default values set in the Océ TDS700 Power Logic
Off-line folding settings (optional)
®
controller application.
®
51
Advertisement
Table of Contents
